Signalexpress Tektronix Edition Serial Number
Trigger tab has these options:Type - Edge; Video or PulseMy present choices of other settings under the trigger tab are:Source - For this portion of my test I am using only channels 3 and 4 and have tried triggering from either oneCoupling - DCLevel - 0.00V (have tried various other small levels with the same resultSlope - RisingHoldoff - 500nsTo ensure there were no conflicts, I uninstalled the Tektronics OpenChoice software and the NI software as well. Then, I reinstalled the NI package. I found a threead that mentioned a.dll file for the USB connection could be a problem if OpenChoice was installed after LabVIEW SignalExpress is installed. Still trigger, stop, trigger, stop, trigger, stop.
Haven't had a chance to try generic IVIs yet. Regarding the scope firmware, it is listed in the Utilities / Misc. Screen as follows:Misc.TDS2014BVersion FV:v23.08Serial Number C101067GBIP Setup Address: 2TEK-USB-488NoneThe NI SignalExpress is Version 2.5.1 (2007 vintage, however, this was recently downloaded from the Tektronics site).I am beginning to wonder if the scope's USB interface can handle the data rate produced by free running.
I have tried even the slowest horizontal rate to minimize the sample rate (to no avail, though).
Additional Features:. Bandwidth: 500 MHz. Input Channels: 4. Sample Rates Up to 2.5 GS/s on All Channels.
Labview Signalexpress Tektronix Edition
10 Megasample Record Length on All Channels. 50,000 wfm/s Maximum Waveform Capture Rate. Suite of Advanced Triggers. Wave Inspector® Controls Provide Unprecedented Efficiency in Waveform Analysis. 10.4 in.
Signalexpress 2015
(264 mm) XGA Color Display. USB and CompactFlash on Front Panel for Quick and Easy Storage. USB Plug-and-Play PC Connectivity. Small Footprint-Only 5.4 in. (137 mm) deep. TekVPI® Probe Interface Supports Active, Differential, and Current Probes for Automatic Scaling and Units.
Comments are closed.